Where: xl-gps responds, When you enter a new user name, xl-gps responds, Enter new user name – Symmetricom XL-GPS User Manual
Page 102: Confirm new user name, Ok<cr><lf
92
997-01530-01, Rev. C-25, Jan 2008
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
1
where:
XL-GPS responds:
ENTER NEW USER NAME:
When you enter a new user name, XL-GPS responds:
CONFIRM NEW USER NAME:
Enter the same new user name again, to confirm the spelling. If the same new user name has been
entered twice, XL-GPS responds:
OK<CR><LF>
In this case, the new user name will be used for the next login using the command line interface.
However, if the new user name is entered differently the second time, XL-GPS responds:
ERROR: USER NAMES DO NOT MATCH. NEW USERNAME REJECTED!<CR><LF>
In this case, the old user name will be used for the next login using the command line interface.
If you have forgotten the operator or guest user name and/or password, use “Bootloader Mode” to
change them. In Bootloader Mode, log in using the default user names (“operator” and ”guest”) and
passwords (
See “Using the Command Line Interface” on page 18.
). Then use F100 PN and F100P to set
the new user names and passwords. Once this has been completed, reboot the unit and log in using the
new username or password.
See “F100 P – Change User Password” on page 90.
Bootloader Mode
To enter Bootloader Mode when resetting a forgotten user name (F100 PN) or password (F100 P):
•
Reboot the XL-GPS using the
command.
•
Immediately press the MENU key on the keypad and hold down while the XL-GPS is rebooting.
The XL-GPS will display will ‘hang’ while displaying “BOOTING”.
•
After a few moments, release the MENU key.
•
Open a command line session with the XL-GPS.
•
Use the F100 PN or F100 P commands as needed and then reboot the XL-GPS again.
F
= ASCII character F
100
= unit
function
number
<S>
= space
PN
= specify User Name command
<CR>
= input
line
terminator