Symmetricom XL-GPS User Manual
Page 85
997-01530-01, Rev. C-25, Jan 2008
75
2
5
1
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
S
The following table gives the command line equivalents for each of the preceding parameters:
Group 2
The following expanded command set is available through the command line interface:
You can reconfigure two or more network parameters in a single entry by sending the F100 command
and entering new values. Leading zeros may be omitted when entering IP Address, Subnet Mask, and
Default Gateway. Any field may be omitted and order is not significant. Blanks are allowed on either side
of a colon. The unit reboots after any network parameter is changed.
Description
“F100” followed by:
Comments
Ethernet address
(MAC address)
EA
Displays information
IP Address
IP
Displays, configures and reboots
Subnet Mask
SM
Displays, configures and reboots
Default Gateway
G
Displays, configures and reboots
IP Address, Subnet Mask,
and Default Gateway
IC
Displays several IP parameters
10 100 BASE-T
BASET
Displays network port setting
Remote Lockout
L (for status), LOCK, UNLOCK Displays and configures
Flash CRC
ST
Displays information
RAM
ST
Displays information
Serial
ST
Displays information
Version Test
(NVRAM Ver)
ST
Displays information
Description
“F100” followed by: Comments
Burn Host
BH
Configure
Burn
BU
Commit action
Burn Bootloader
BUB
Commit action
Burn Filesystem
BF
Commit action
Configure NTP & SNMP Parameters CONFIG
Move files
Factory Mode Jumper
J
Display only
Reboot
K I L L
Commit action – reboot the XL-
GPS
Change User Password
P
Configure
Ping
PI
Commit action
Change User Name
PN
Commit action