Symmetricom XL-GPS - Manual (Page 93)

997-01530-01, Rev. C-25, Jan 2008 83
2
5
1
S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S S
where:
An example of the response is:
F100 ST FLASH/CRC : PASS, RAM : PASS, SERIAL : PASS, NVRAM VER : PASS<CR><LF>
F100 BH – Burn Host
Use function F100 BH, when upgrading firmware, to select the FTP host and the file to be transferred.
To select the FTP host and file for upgrading, enter:
F100 BH <FTP HOST IP ADDRESS><S><UPGRADE FILE PATH>/<FILE NAME><CR>
Use UNIX style forward slashes ‘/’ in path and do not describe the drive (for example, ‘C’) in the path.
For example:
F100 BH 10.1.7.20 symmetricom/XL-GPS/192-8001.bin<CR>
XL-GPS responds:
BURN HOST IS READY!!!<CR><LF>
F100 BUB – Burn BootLoader
Note: See “B: Upgrading System Firmware” on page 118.
When upgrading the system firmware, use function F100 BUB to burn the BootLoader, to write the
BootLoader to flash memory.
F
= ASCII character F
100
= Unit function number
<S>
= Space
ST
= Specify ST command
FLASH/CRC:
= Specify flash checksum result
RAM:
= Specify RAM test result
SERIAL:
= Specify Serial Port test result.
NVRAM VER:
= Specify version test result. This test compares the version of the code against the version
recorded in Non-Volatile memory
<STATUS>
= Is either ASCII PASS or FAIL
,
= ASCII comma
:
= ASCII colon
<CR><LF>
= Output line terminator