Schneider Electric ALTIVAR 58 TRX - Manual (Page 52)

Altivar ® 58 TRX AC Drives
Function Compatibility
© 2000–2003 Schneider Electric All Rights Reserved
52
09/2003
FUNCTION COMPATIBILITY
The table below shows the I/O functions that are not compatible with each other. Any function not listed
in this table is compatible with all other functions.
Aside from the particular functions shown in this table, two general priorities exist:
• Stop functions always have priority over Run commands.
• Speed references via logic command always have priority over analog setpoints.
In addition, the choice of functions is limited by:
• The number of controller inputs and outputs to be re-assigned.
• The incompatibility of certain functions with others.
➞ ➞
➞ ➞
➞
➞
➞➞
Automatic DC injection braking
Summing inputs
PI Regulator
+Speed/-Speed
Reference switching (Auto/manual)
Freewheel stop
PI regulator with Auto/manual
Fast stop
Jog
Preset Speeds
Reverse operation
Inhibit reverse operation
Automatic DC injection braking Summing inputs PI Regulator +Speed/-Speed Reference switching (Auto/manual) PI regulator with Auto/manual Freewheel stop Fast stop Jog Preset Speeds Reverse operation Inhibit reverse operation
➞ ➞
Incompatible functions
Compatible functions
No significance
Function priority (functions which cannot be active at the same time):
The arrow points to the function that has priority.
The stop functions have priority over run commands.
The speed references from a logic command have priority over analog references.
Note: An incompatible function must be deselected before the desired function can be programmed.
For example, if preset speeds is programmed, it must be cleared before the +/- speed parameter
can be selected.
Speed regulation with
tachogenerator or encoder
Torque limitation via AI3
Torque limitation via LI
Speed regulation with tachogener
ator or encoder
T
o
rque limitation via AI3
T
o
rque limitation via LI
C
o mp
at
ib
ili
ty
T
a b le
-ad
d (
c
a ta
log)
.e
ps