Server Technology PP02 - Manual (Page 35)

1 2 3 4 5 6 7 8
ON
Infinite-On/Off Mode
1 Ring/Hang-up to 'prime', wait 10 seconds then place second call:
5 RINGs to Power-ON, or
15 RINGs to Power-OFF
This configuration is for users who prefer the Remote Power On/Off to behave like a real switch -- to power-ON and stay
on, or power-OFF and stay off. In this mode, line-sharing is not possible; only a single phone device (i.e. modem) can be
attached to the A
UX port - the M ODEM port will be empty.
1 To switch power ON -- The user places a first call to the phone number of the line attached to the Power On/Off
+Aux. After one ring is heard, the caller waits a couple of seconds then hangs-up. After 10 seconds, this first call
will prime the Remote Power On/Off system for two minutes. Within the two minute 'window', the user places a
second call and allows at least five (but less than 15) RINGs -- the IPM will switch ON, after the fifth ring, and
remain ON even after the calls hangs-up.
2 The PC boots, a command in the host PC's AUTOEXEC.BAT file loads the host/communications software (i.e.
HyperAccess), and the modem is initialized to answer on ring 3. After the two minute 'window' has expired (2
minutes after the first call), the system will be in an infinite-ON state, ready to accept incoming calls. The power
will remain on during and after all sessions. Direct calls will be answered by the modem on the third ring.
3 To switch the power OFF -- The user places a call to the Power On/Off +Aux. After one ring is heard, the user
hangs-up. Again, after 10 seconds, this first call will prime the Remote Power On/Off system for two minutes.
Within the two minute 'window', the user places a second call and allows at least fifteen RINGs to occur - the IPM
will switch OFF and remain off.
Remote Power On/Off Sample Sessions • 35