Server Technology PP02 - Manual (Page 12)

Installation
This section covers the initial installation and testing of the Power On/Off +Aux control unit and the Intelligent Power Module (110vAC
version). For additional installation information regarding the Windows 95/98/ME and Windows NT/2000/XP ShutDown/
RE BOOT
versions refer to Appendix B and Appendix C respectively. For the 220VAC IPM, refer to page 39 of Appendix A.
Default Settings
Installation should be performed with the factory default DIP-switch configuration as shown below. Switch numbers 2
and 5 are ON (down):
1 2 3 4 5 6 7 8
ON
Install the Intelligent Power Module (IPM)
Toggle the IPM 0|1 switch to the INPUT (0) position. Plug the IPM in-line between a live AC outlet and a multiple
outlet surge strip. Next, plug the PC and associated peripherals' power cables into the outlet strip. The power switch on
the PC and peripherals must be set and remain in the ON position. Toggle the IPM switch to the ON (1) position and the
PC and associated devices should power ON. Toggle the IPM switch back to the INPUT (0) position and the PC and
associated devices should power OFF.
The switch should remain in the INPUT (0) position.
NOTE: For systems with an Uninterruptible Power Supply (UPS; a battery back-up), the UPS plugs into the live AC
outlet and the IPM plugs into an outlet provided by the UPS. The switch on the UPS must always remain on.
Insert one end of either included telephone cable into the IPM's port labeled "Input". This is now the IPM Signal Cable.
For an example of what the system should look like once installed, see the Before and After diagrams on pages 13 and 14.
Install the Power On/Off +Aux Control Unit
Position the Power On/Off +Aux Control Unit in a suitable spot near the PC. The Master "ON/OFF" switch is located on
the face of this unit, so choose a location on the desktop that is easily accessible. Next, plug the wall-mount power
supply into another live AC outlet (not controlled by the IPM) and insert the plug into the jack labeled "Power" on the
rear of the control unit. The "S
TATUS " light should begin to flash.
Remote Power On/Off Installation • 12