Server Technology PP02 - Manual (Page 36)

Appendix A
ON/OFF and S TATUS LED Activity
The front panel of the Power On/Off +Aux control unit contains two indicator lights. These LEDs inform the user of the
current power status, present phone-line condition, and indicate whether or not the power has been activated remotely
since it was last turned off manually. The activity of both lights varies according to the Operating Mode you have
chosen.
ON/OFF Light
Power-ON and Infinite-On/Off Modes
In the Power-ON Mode and Infinite-On/Off Mode the ON/OFF light indicates the current status of the power signal sent
to the IPM. There are four possible states for this light:
• OFF ~ The IPM should not be providing any power. The LED is solid OFF.
• FLASHING FAST ~ The power was activated remotely via RING and is ON. In this state the LED will illuminate
2x per second.
1/4 second ON - 1/4 second OFF
• ON ~ The power was activated manually by the master switch and is ON. The lamp is solid ON.
• FLASHING SLOW ~ Indicates that the power was activated manually by the master switch, is ON, and the 15 Ring
Turn-Off option is enabled or the Infinite-On/Off Mode is being used In this state, the lamp will flash in a 4 second
cycle.
3 seconds ON - 1 second OFF
RE BOOT Mode
In the RE BOOT Mode the ON/OFF lamp will have only three possible states:
• FLASHING ~ The power is ON and the RE BOOT function is enabled. In this state the LED will illuminate 2x per
second.
1/4 second ON - 1/4 second OFF
Remote Power On/Off Appendix A | LED Activity • 36