Seiko Group SII IP-6600 - Manual (Page 174)

4-6
Parameter Setup Mode
This mode is used when the operator sets the heater control system
parameters.
(1) Setup items and parameters
The setup items and parameters are listed in the table below.
*1 Display only, ON/OFF key is ignored.
(2) Entering the parameter setup mode
Press the ON/OFF key, key, and key on the heater control
panel at the same time to enter to the parameter setup mode.
The 1st setup item in the parameter setup mode will be displayed.
Note: # will be blinked.
No. Item
Item Display
(upper line)
Parameters
Display
(lower line)
Description Initial value
1 Temperature unit UNIT
CELSIUS
FAHRENHEIT
- CELSIUS
2
Heat suspending
time after printing
DELAY TIME 00 to 30 MINUTE UNIT: minute 05 MINUTES
3
Standby heating
time after
completion of
DELAY TIME
STANDBY TIME
0, 30, 60, 90, 120,
ENDLESS
Unit: minutes 30
4 Version display VERSION FW=vv.r HW=vv.r Display only -
5 Diagnostics DIAGNOSTICS NO, YES
NO: Does not perform
the diagnostics.
YES: Performs the
diagnostics.
NO
6 Display language LANGUAGE
ENGLISH
JAPANESE
- ENGLISH
7 Exit of setup mode EXIT YES, NO
YES: Exits from the
parameter mode.
NO: Does not exit from
the parameter mode.
YES
# UNIT
* CELSIUS