Seiko Group SII IP-6600 - Manual (Page 63)

2-19
Section 2 Basic Operations
Installing/Removing Cut Sheet in/from the Printer
Install/Remove the cut sheet in/from the printer refering to the
procedures for the paper roll.
Installing Removing
- When installing the cut sheet in the printer, set the cut sheet
using the guide line.
NOTE
Cut sheet
Guide line
Cut sheet
Replacing the Paper Roll
Paper Feed Adjustment Correction Value Setting
1
Set the paper of width larger than A1 size and length
longer than 1m. (Press the key)
For the paper feed correction, obtain approximate paper feed adjustment
correction value in the ROUGH mode, and set exact correction value in the
DETAIL mode. One printing requires the paper length of 48 to 58 cm in the
ROUGH mode, or 27 to 32 cm in the DETAIL mode. (Printing of paper
feed adjustment pattern can be cancelled by pressing the key.)
- If you use the tension winding, be sure to set the paper feed
adjustment correction value in the tension winding mode.
- Longer print length is required in the tension winding mode.
NOTE