Seiko Group SII IP-6600 - Manual (Page 52)

2-8
<Heater>
1
Turn OFF the heater switch on the right rear of the
printer, and plug one end of the supplied power cable into
the socket of the printer. Insert the other power plug of
the cable into an electrical outlet.
2
Turn ON the heater switch on the right rear of the printer
to turn the heater ON.
Heater switch OFF (0)
Power socket
Power cable
Heater switch ON (1)
100/200 V alternation switch
100/200 V alternation switch
- Do not use the other power cable than specified in this printer.
- Verify that the supplied power cable meets the local AC power
supply specifications.
- Verify that the 100 / 200 V alternation switch settings meets
the local AC power supply specifications.
NOTE