SVAT Electronics CLEARVU10 - Manual (Page 58)

58 CLEARVU10
SVAT ELECTRONICS
now you can see
3. The OPERATION option allows you to enable or disable the alarm out setting. Use the buttons to enable or disable this feature. If enabled,
you will be able to edit settings for up to 8 alarms. If disabled, alarms will not function if there is an event.
4. Use the mouse to check the alarm, video loss, or motion boxes accordingly. If you select VIDEO LOSS, your alarm will sound if the camera loses
power. MOTION will sound the alarm if the camera detects motion. Checking the ALARM box will cause the DVR to send an alarm out if an
alarm is detected.
5. The MODE can be set as LATCHED or TRANSPARENT. TRANSPARENT causes the alarm to sound for the duration of the event (for example, if
motion is detected, the alarm will sound for the entire time that there is movement). The LATCHED setting means that the alarm will sound
for a set duration of time, which you will decide in step 6.
6. If you have chosen LATCHED in step 5, you can use the buttons to set the duration of the alarm to be between 5 and 300 seconds or until a
user logs on to the system (UNTIL KEY-IN).
7. The HDD EVENT can be turned on or off. This determines whether hard drive errors trigger the alarm output.
8. When you have made all the desired changes to the ALARM OUT menu, click APPLY. If you wish to exit without saving changes, click in the
top right corner of the window.
1. After saving any desired changes to other
menus Click the BUZZER OUT title on the
left hand side of the window.
2. You will see a window open with the
8 channels listed. You will see the
choice to have the DVR’s speaker sound
an alarm if video loss or motion is
detected.
3. The OPERATION option allows you
to enable or disable the DVR’s alarm.
Use the buttons to enable or disable this
feature. If enabled, you will be able to edit
settings for up to 8 cameras. If disabled,
the DVR will not beep if there is an event.
MAKING CHANGES TO THE BUZZER OUT MENU
4. Use the mouse to check the ALARM, VIDEO LOSS, and MOTION boxes accordingly. If you select VIDEO LOSS, the DVR will sound if the camera
loses power. MOTION will sound the DVR’s alarm if the camera detects motion. Checking the ALARM box will cause the DVR to sound the
buzzer if an alarm is detected.
5. The MODE can be set as LATCHED or TRANSPARENT. TRANSPARENT causes the alarm to sound for the duration of the event (for example, if
motion is detected, the alarm will sound for the entire time that there is movement). The LATCHED setting means that the alarm will sound
for a set duration of time, which you will decide in step 6.
NOTE: The ALARM IN and ALARM OUT menus configure settings for an external alarm device (for example, a motion sensor) or an independent
alarm which will sound when an event is detected. The setup and activation processes of these devices will very from model to model, so
please refer to your sensor or alarm’s instruction manual for proper setup.