Smart Technologies SMART Audio 340 - Manual (Page 18)

Introduction
Your microphone uses a line of sight infrared signal to transmit your voice to the room module or an
expansion sensor. The maximum distance for this is 15' (4.6 m).
You can recharge the microphone’s batteries using the included charging cradle.
Assembling the microphone
Your microphone has a battery, a protective sleeve and a lanyard.
g To start using your microphone:
1. Install the battery in the microphone (see Installing or replacing the microphone battery on the
next page).
2. Slide the microphone into the protective sleeve.
3. Connect the lanyard to the microphone, if desired (see Connecting the lanyard to the
microphone on the next page).
4. Charge the microphone by placing the microphone in the charging cradle (see Charging the
microphone on page 14).
5. Turn on the microphone (see Turning on and turning off the microphone on page 15).
6. Connect the microphone to the room module (see Connecting the microphone to the room
module on page 15).
7. Adjust the volume (see Speaking into the microphone on page 16).
C H A P T E R 3
Using the microphone
12