Smart Technologies SMART Audio 340 - Manual (Page 39)

Uploading a configuration file
After you edit the settings, you can upload the configuration file to the control unit or to another control
unit in another room.
g To upload configurations to the control unit
1. 1. Start SMART Audio configuration software, and then select the Setup tab.
2. Click the Upload Configuration File to the CU button.
SMART Audio configuration software settings are uploaded from your computer to the control
unit.
Saving a configuration file
After you edit your settings, you can save the configuration file to your computer as a backup or to
upload to another SMART Audio system control unit.
g To save a configuration file
1. Start SMART Audio configuration software, and then select the File > Save or File > Save
as.
2. Type a file name, and then click OK.
SMART Audio software settings are saved to the file.
Setting the volume
The Volume tab enables you to do the following:
l
Set a master default volume for all audio input devices.
l
Set specific default volumes for specific audio input devices.
You can set an auxiliary input volume from -30 dB to 8 dB. You can set microphone volumes from -40
dB to 6 dB.
Other volume controls are based on these settings.
g To set the master default volume
Move the Master slider on the Volume tab up or down.
OR
Change the volume by moving the up or down arrow.
C H A P T E R 5
Customizing your settings
33