Sun Microsystems Sun Fire V490 - Manual (Page 191)

Chapter 9 Configuring System Firmware 163
2. To effect the changes immediately, type:
Note – To immediately effect the changes, you can also power cycle the system
using the front panel Power button
How to Reconfigure a Device Manually
Before You Begin
You can use the OpenBoot asr-enable command to reconfigure any device that
you previously deconfigured with asr-disable. For background information, see
■ “About Manually Configuring Devices” on page 59
What to Do
1. At the system ok prompt, type:
where the device-identifier is one of the following:
■ Any full physical device path as reported by the OpenBoot show-devs command
■ Any valid device alias as reported by the OpenBoot devalias command
■ An identifier for a device or a range of devices given in “Reference for Device
Identifiers” on page 61
2. Do one of the following:
■
If you are reconfiguring a processor, power cycle the system using the front panel
Power button.
■ If you are reconfiguring any other device, type:
ok reset-all
ok asr-enable device-identifier
ok reset-all