Simrad EQ60 - Manual (Page 57)

Operational procedures
45
857-164342 / Rev.C
Transceiver installation
Overview
Use the following procedures to install, modify or delete
frequency channels from the echo sounder set-up.
The ISA bus in the built-in transceiver is searched for available
channels, and these are displayed in a list.
General Purpose Transceivers (GPT) physically connected to the
echo sounder’s ethernet interface are identified automatically by
the system. When you open the
Transceiver Installation
dialogue box from the Install menu, a list will be provided.
A single frequency transceiver occupies one entry in the list, and
a dual frequency transceiver occupies two. Each entry is
identified as a frequency channel, and the line displays the
parameters for the channel. Entries in the frequency channel list
are shown in black,
green or red colour identifying its current
status.
To install a channel
1 Select Transceiver on the Install menu.
2 Select Modify in the Transceiver Installation Mode
dialogue box.
- The Transceiver Installation dialogue box opens, and
you are allowed to make changes.
3 Click the desired entry (one of the black colour line
alternatives) in the Frequency Channel Selection list.
4 Assign a transducer by selecting a transducer name in the
Transducer Selection list.
5 Click OK to accept the choice and exit the dialogue box.
6 Restart the echo sounder as described below.
Related topics
→
Transceiver Installation, page 112
To uninstall a channel
1 Select Transceiver on the Install menu.
2 Select Modify in the Transceiver Installation Mode
dialogue box.
- The Transceiver Installation dialogue box opens, and
you are allowed to make changes.