Sanyo DWM-3500 - Manual (Page 10)

-E9-
Note:
Do not connect the power cord to a 120V AC 60Hz outlet
until all connections have been made.
TV Antenna Connections
If you are using an antenna system, follow these instructions. If
you are a cable (CATV) subscriber, skip ahead to page E12 for
the proper connections.
The main unit must be connected “between” the antenna and the
TV. First, disconnect the antenna from the TV and connect it to
the main unit. Then connect the main unit to the TV. Below are 3
common methods of connecting an antenna system to a main
unit. Find the type of antenna system you are using and follow
the connection diagram.
Example 1: Combination VHF/UHF antenna with 75 ohm
coaxial cable
Example 2: Combination VHF/UHF antenna with 300 ohm
twin lead (flat) wire
Example 3: Separate VHF and UHF antennas
Note:
If both VHF and UHF antennas have 300 ohm twin lead (flat)
wires, use a combiner having two 300 ohm inputs and one 75
ohm output.
Notes:
•
A clear picture will not be obtained by the main unit unless the
antenna signal is good. Connect the antenna to the main unit
properly.
• For better quality recording, an indoor antenna or a telescopic
antenna is not recommended. The use of an outdoor type
antenna is required.
• If you are not sure about the connection, please refer to
qualified service personnel.
300 ohm twin lead
(flat) wire
3 CH 4 CH
VIDEO
AM LOOP
AUDIO AUDIO OUT (6–CHANNEL)
L
R
IN
VHF/UHF
ANT ( )
OUT
TV ( )
DVD/VCR OUTPUT
FM 75 Ω
Main unit
Matching transformer
300 ohm input
75 ohm output (not supplied)
VHF UHF
3 CH 4 CH
VIDEO
AM LOOP
AUDIO AUDIO OUT (6–CHANNEL)
L
R
IN
VHF/UHF
ANT ( )
OUT
TV ( )
DVD/VCR OUTPUT
FM 75 Ω
Main unit
Combiner
75/300 ohm inputs
75 ohm output (not supplied)
300 ohm twin
lead (flat) wire
75 ohm coaxial
cable
BASIC CONNECTIONS
75 ohm coaxial
cable
Main unit
3 CH 4 CH
VIDEO
AM LOOP
AUDIO AUDIO OUT
(6–CHANNEL)
L
R
IN
VHF/UHF
ANT ( )
OUT
TV ( )
DVD/VCR OUTPUT
FM 75 Ω
2B80201A [E] P01-16 24/2/03, 7:13 PM 9