Sanyo DWM-3500 - Manual (Page 37)

-E36-
Stereo Recording and Playback
The VHS Hi-Fi audio system permits high fidelity recording of
MTS STEREO TV broadcasts.
When a MTS STEREO broadcast is received, the word STEREO
will appear on the TV screen and the program can be viewed or
recorded in stereo.
The Hi-Fi STEREO recording procedure is the same as for
normal recordings.
STEREO
Note:
When using a CATV system, stereo TV programs may be
transmitted over a mono cable channel. In this case the word
“STEREO” will not appear and the sound will be in mono.
Output selection
When viewing an MTS STEREO TV program, or playing a
prerecorded VHS Hi-Fi STEREO videotape, press [AUDIO OUT]
to select how the audio will be heard through the speakers.
Normally set to the Hi-Fi STEREO position, this button can be set
to the MONO position if the stereo broadcast or videotape audio
is of poor quality. The “R” and “L” positions allow the audio from
the Right or Left Hi-Fi channel to be heard over both TV speakers.
This button has no effect when viewing a MONO videotape or TV
program. Each time when you press the button, OUTPUT
SELECTION display appears on the TV screen for several
seconds. Refer to the chart below.
OUTPUT SOUND HEARD ON BOTH
SELECTION SPEAKERS
STEREO STEREO
L ch LEFT CHANNEL AUDIO
R ch RIGHT CHANNEL AUDIO
MONO MONO
AUDIO OUT
Notes:
•
When playing back a tape that is not recorded in Hi-Fi stereo
mode, the audio will automatically be monaural.
• When listening to a VHS Hi-Fi video tape or MTS broadcast
through the VHF/UHF jack (Audio/Video cord not connected),
the sound will be monaural.
Separate Audio Program (SAP)
Your VCR is fitted with a SAP broadcast system which enables
you to switch to a separate audio program when viewing a
selected channel.
This function applies only when the program is broadcast in
multi-languages through the SAP broadcast system.
3 2
1, 4
1. Press [SETUP/MENU].
The “MENU” screen appears on the TV screen.
〈 4 / 5 /ENTER/MENU 〉
MENU
TIMER REC SET
AUTO REPEAT ON OFF
ON OFF SAP
CH SETUP
SYSTEM SETUP
SPEAKER SETUP
TVGuardian SETUP
2. Press [ 4 ] or [ 5 ] to select “SAP”.
3. Press [ENTER] to select “ON”.
〈 4 / 5 /ENTER/MENU 〉
MENU
TIMER REC SET
AUTO REPEAT ON OFF
ON OFF SAP
CH SETUP
SYSTEM SETUP
SPEAKER SETUP
TVGuardian SETUP
4. Press [SETUP/MENU] until the menu screen is cleared.
Listening to SAP
When the VCR is turned on or a channel selection is made, make
certain the letters “SAP” appears on the TV screen. This means
that the “Separate Audio Program” broadcasting is available.
SAP STEREO SAP
OR
2B80201A [E] P27-37 24/2/03, 7:14 PM 36