Power supply (main unit and powered subwoofer), Fm antenna, Am antenna – Sanyo DWM-3500 User Manual

Page 17: Caution

Advertising
background image

-E16-

Need help? Call
1-800-813-3435

AM/FM Antenna Connections

FM antenna

The FM indoor antenna lead wire is sufficient to receive most
local FM signals.

1. Unwind the antenna lead wire.

2. Twist the end of the wire and pull it off.

3. Connect it to the rear FM 75

terminal. See the illustration

on the right.

4. Extend it as straight as possible and, while listening to the

sound from the system, secure it in a position where the best
FM reception is found.

In fringe areas, or where reception is distorted or noisy, an FM
outdoor antenna (not supplied) should be connected instead of
the FM indoor antenna lead wire. The terminals will accept 75-
ohm coaxial cable.

AM antenna

The AM loop antenna is sufficient to
receive most local AM broadcasts.
Assemble the loop antenna.

Unwind the antenna wires, then connect
them to the AM LOOP terminals. Place
the loop antenna in a position which
yields the best AM reception, or attach
it to a wall or other surface as shown.

Note:
To minimize noise...

Keep the speaker wires, power cord and all other system
connection cables away from the loop antenna.

Do not place the antenna close to a TV or speaker.

Note to CATV system installer:
This reminder is provided to call the CATV system installer’s
attention to Section 820-40 of the NEC which provides guidelines
for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.

Power Supply
(Main Unit and Powered Subwoofer)

Connect the power cord to a 120V AC 60Hz outlet. This unit is
equipped with a polarized plug. If you have difficulty inserting the
plug, turn it over and reinsert it. If the unit will not be used for a
long time, disconnect the AC plug from the AC outlet.

The powered subwoofer will automatically turn on when the main
unit is turned on.
The POWER indicator lights on the powered subwoofer.

Notes:

Before plugging the power cord into an AC outlet, make sure
that all the connections have been made.

The main unit and powered subwoofer are not disconnected
from the AC power unless the power cord is unplugged from
the AC outlet.

1

2

1

2

3

3

CH

4

CH

S-VIDEO

COMPONENT

VIDEO

AM LOOP

AUDIO

AUDIO OUT

(6ÐCHANNEL)

L

R

IN

VHF/UHF

ANT

(

)

OUT

TV

( )

Y

P

B

P

R

DVD OUTPUT

DVD/VCR OUTPUT

FM 75½

AM LOOP

FM 75½

Ground

CAUTION:

When installing an outdoor antenna, follow the installation
instructions in “IMPORTANT SAFETY INSTRUCTIONS” on
page E2.

Screws (not supplied)

FM outdoor antenna
(not supplied)

Antenna discharge unit (not supplied)

AM loop antenna

FM indoor
antenna lead
wire

75-ohm coaxial cable
(not supplied)

Main unit

White

Black

2B80201A [E] P01-16

24/2/03, 7:13 PM

16

Advertising