Kathrein UFD 170 - Manual (Page 12)

Controls, Displays and Connections
12
Remote control instruction sets
The remote control has two instruction sets. This alllows you to operate
two receivers independently of one another in the same room.
Hold down the

key.
Enter “901” using the number keys.
To transfer the code, switch receiver 1 to standby with

, and then
turn the unit off with the power switch.
Start up receiver 2 again.
Hold down the

key.
Enter “902” using the number keys.
To transfer the code, switch receiver 2 to standby with

, and then
turn it back on.
Start up receiver 1 again.
Hold down the

key.
Enter “903” using the number keys.
For the fi rst two settings, the remote control must be pointed at the
relevant receiver turned on.
You can now use the

key to change between the two instruction
sets A and B (toggle function), and operate the two receivers
alternately.
As supplied, instruction set 1 is always activated by default.
If you are only operating one receiver, and the active instruction set is
accidentally changed so that you can no longer operate the receiver,
the remote control can be switched back to instruction set 1 with no
problems. This procedure is described above.
To use this feature, program the fi rst receiver to instruction set 1 and the
second to instruction set 2.
First turn on receiver 1 and then receiver 2 using the power switch.
Note: This does not work in conjunction with a twin receiver!
Important information on the remote control
You can only operate the UFD 170 using the remote
control (RC 400) supplied. Without the remote control,
it is not possible to set up or control the receiver and
the turntable. Therefore, you should always take good
care of your remote control and make sure you have
spare batteries for it.