Kathrein UFD 170 - Manual (Page 58)

Installation Menu
58
UFO®mini
In a “subscriber controlled processing system”, the input frequency of
the receiver is a fi xed setting. The “subscriber controlled processing
system” transmits the signals at this frequency. The reception
parameters for programme selection are communicated to the
receiving system by a DiSEqC™ command and set.
The setting that has to be selected depends on the design of the
“subscriber controlled processing system”.
Remote Frequency
If you have set the “UFO®mini” menu option to “On”, use this menu mini mini
option to make the setting from the transmission frequency.
For the transmission frequency to be set, refer to the installation
manual for the “subscriber controlled processing system”.
It is essential that you follow the instructions in the “subscriber
controlled processing system” installation manual.
UFO®micro
The setting for this menu option is also designed for operation of the
receiver in a processing system.
The return path of the coaxial cable is used for control and
communication between the receiver and the Kathrein UFO®
The return path of the coaxial cable is used for control and The return path of the coaxial cable is used for control and
micro
system. If the receiver is operated in a UFO®micro receiving system,
the “UFO®
system. If the receiver is operated in a UFO system. If the receiver is operated in a UFO
micro” menu option must be set to “On”.
The receiving system then assigns the receiver a special address upon
installation, so that it will recognise the control commands sent by the
receiver to the receiving system for signal selection.
In this operating mode, a remote frequency need not be set, as it is
specifi ed by the UFO®
In this operating mode, a remote frequency need not be set, as it is In this operating mode, a remote frequency need not be set, as it is
micro system with the addressing.
If the receiver is being used in a UFO®micro receiving system for the
fi rst time, the address previously assigned must be deleted. This is
done in the “UFO®
fi rst time, the address previously assigned must be deleted. This is fi rst time, the address previously assigned must be deleted. This is
micro” menu option by selecting “Reset” using the

done in the “UFO done in the “UFO
and

keys. The receiver is then assigned the original factory
setting. It then needs to be set to “On” again. The receiver receives its
new address from the new system.
Default setting: “Off”. “Reset” does
not delete the
pre-programming.
Factory Settings
This item allows all parameters to be reset to the factory settings using
the

key. The factory settings do not necessarily correspond to the
settings required for your specifi c system.
After resetting, you may need to make all settings again.