Kathrein UFD 170 - Manual (Page 9)

Connection and Setup
9
Connect the UFD 170 (TV Scart socket) and the TV set with a Scart
cable. If your TV has a stereo feature, you can receive the sound in
stereo via the Scart connection.
Audio Connection
Dolby Connection
If you want to play the sound on your hi-fi system, connect the
audio cinch sockets to the input sockets on the hi-fi system with an
appropriate cable.
The Dolby Digital data fl ow output (AC 3) is intended for connection to
a Dolby Digital system.
TV Connection
Connect the infrared receiver to the “IR REMOTE IN” socket and
position it such that it has a visual connection to the remote control. The
UFD 170 can only be operated by remote control.
IR Receiver
Inserting Batteries in the Remote Control
Remove the cover on the rear of the remote control. Insert the two
batteries supplied into the remote control, ensuring correct polarity -
this is shown on the base of the battery compartment.
Slide the cover back onto the housing until it clicks into place. Used
batteries are special waste. Do not throw used batteries into your
household waste; take them to a collection point for old batteries.
Electronic equipment is not household waste - in accordance with
directive 2002/96/EC OF THE EUROPEAN PARLIAMENT AND THE
COUNCIL of 27 th January 2003 on used electrical and electronic
equipment, it must be disposed of properly.
At the end of its service life, take this unit for disposal at a relevant
offi cial collection point.