Kenwood NV-701 - Manual (Page 7)

Preparation section
7
System connection
Speaker placement in a multichannel home theater
setup
Front speakers: Place to the front left and right of the
listening position at equal distances from both the unit and
the listening position. Front speakers are required for all
surround modes.
Center speaker: Place front and center. This speaker
stabilizes the sound image and helps recreate more natu-
ral sound motion.
Surround (rear) speakers: Place to the direct left and
right, or slightly behind, the listening position at even
heights approximately 1 meter (3.5 ft.) above the ears of
the listeners. These speakers recreate rear sound motion
and atmosphere, and are required for surround playback.
Subwoofer: Reproduces deep bass and other low fre-
quency sounds.
By performing the “Surround Options” setup operations,
this unit makes automatic adjustments to account for the
way the speakers have been set up in order to deliver the
best possible surround sound.
)
Center
speaker
Subwoofer
Front speaker
Surround speaker
CAUTION
(For U.S.A., U.S.-Military and Canada)
Be sure to adhere to the following or proper ventilation
will be blocked causing damage or fire hazard.
÷ Do not place any objects impairing heat radiation onto
the top of this unit.
Speaker and TV installation
The magnet in the speakers may cause color irregularity
if set on the TV. If this occurs, place the speaker farther
away from the TV set.
Malfunction of the microcomputer
If operation is not possible or an erroneous display
appears even though all connections have been made
properly, reset the microcomputer. Refer to “In case of
difficulty”. ¨
Notes Notes
1.Be sure to insert all connection cords securely. If connections are not secure, the sound may not be
produced or noise may interfere.
2.Before plugging or unplugging a connection cord, be sure to unplug the power cord from the wall AC
outlet. If connection cords are plugged or unplugged with the power cord left plugged in, malfunction
or damage may result.
CAUTION
Be sure to adhere to the following or proper ventilation will be blocked causing damage or fire hazard.
• Do not place any objects impairing heat radiation onto the top of unit.
• Do not place a speaker or any other object next to the ventilation holes on the left side of the main unit. For proper
ventilation, be sure to provide sufficient space on the left side of the main unit.
• Leave a space around the unit (from the largest outside dimension including projection) equal or greater than, shown
below.
Top panel : 50 cm Side panel : 10 cm Back panel : 10 cm