Kodak 9090DC - Manual (Page 10)

A-61662 October 2011 1-5
11 Exit tray — where document(s) are deposited after they have
passed through the transport. There are two sets of slots that are
used for exit tray positioning depending on the types of documents
being scanned.
These positions are available:
- Flat: exit tray rests on top of the scanner in a flat, horizontal
position, with the tabs on the back of the tray hinged into the
bottom row of slots.
- Tilted Forward: tabs at the back of the exit tray are in the top
slots causing the exit tray to tilt in a downward position. This
position aids stacking of long documents in the exit tray.
- Tilted Backward: tabs at the back of the tray are in the bottom
row of slots. Pull the kickstand wire on the bottom of the exit tray
down and out. Snap the kickstand wire in the slots of the
scanner cover. This is useful when scanning small documents.
NOTES:
• If you have the optional imprinter, there is a door underneath the exit
tray that allows access to the front page imprinter.
• If you are using the optional straight pass-through adapter, you can
remove the exit tray from its position and place it in the back of the
scanner for straight pass-through output. For information on installing
and using the straight pass-through adapter, see Appendix C,
Installing and Using the Straight Pass-Through Adapter.
Tabs
Back of exit tray
Top/Front view of scanner - exit tray removed
Top row
Bottom row
Slots-
(slide into
slots)
Stops for bracing
kickstand wire