Kodak 9090DC - Manual (Page 62)

6-10 A-61662 October 2011
11. Exit sensor: The exit sensor is located on the transport toward the
back of the scanner. Clean the exit sensor by placing the brush end
of the blower brush into the exit sensor area and squeeze the
blower brush several times.
12. When all sensors are clean, close the scanner cover and reset the
maintenance reminder by clicking on the Clean Optics link on the
Maintenance monitor.
13. Click Reset on the dialog box to confirm the optics have been
cleaned. The reminder will be reset for the next required
maintenance session.
Exit sensor