Kodak 9090DC - Manual (Page 34)

4-14 A-61662 October 2011
Scanner Self Test — displays the results of the internal scanner fault
monitoring. A green checkmark icon indicates that no scanner faults
were detected.
A red X icon indicates one or more scanner faults were detected. The
text box will list each fault detected.
If the Self Test monitor displays a fault(s), power cycle the scanner and
check the Scanner Self Test monitor again. If the problem persists,
refer to Chapter 7, Troubleshooting.
Maintenance monitor — this section of the Home screen displays any
scanner maintenance and the type of maintenance needed (i.e., clean
transport, replace feed rollers, etc.). Monitored maintenance includes:
• Clean feed rollers
• Clean transport
• Clean optics (e.g., imaging guides, camera glass covers, sensors)
• Replace feed rollers
• Calibration of the front/back camera
• Replace imprinter ink cartridge (if optional imprinter is installed)
The Maintenance monitor also displays when or how soon specific
maintenance should occur in the form of a bar graph. See Chapter 6,
Maintenance for detailed maintenance procedures.
When a maintenance item’s pre-set interval expires, the scanner’s
Maintenance indicator will blink slowly, the icon will change from blue to
yellow and the bar graph will be red. In addition, an alert will be
displayed (yellow triangle).
NOTE: The presence of a red bar graph will not disrupt or stop the
scanner.