Kodak 9090DC - Manual (Page 57)

A-61662 October 2011 6-5
5. Re-install the pick roller.
6. Remove the drive roller by pushing the roller to the right. Hold the
drive roller shaft in place and slide it off the shaft. Gently release the
drive roller shaft back into position.
7. Using a roller cleaning pad, scrub the roller tires using a side-to-side
motion. Rotate the roller to clean the entire surface.
8. Re-install the drive roller.
Cleaning the separation roller
9. Pull the separation roller door forward and remove the separation
roller.
NOTE: The separation roller cover is spring-loaded. Hold the
separation roller cover back until you remove the
separation roller, then gently lower the roller cover back in
place.
10. Using a roller cleaning pad, scrub the roller tires using a side-to-side
motion. Rotate the roller to clean the entire surface.
11. Re-install the separation roller by aligning the slots on the
separation roller with the holders.