Kodak 9090DC - Manual (Page 23)

A-61662 October 2011 4-3
Status The status area of the control panel consists of: Power Mode, Back
Door, Maintenance and Manual Feed.
Power Mode — this green LED indicates the power status or transition
between power modes.
When the scanner is in sleep mode, the Power Mode LED is the only
indicator that is active; all others are off.
Depending on the current Power Mode, the buttons on the control panel
perform different actions. The following table identifies the function of
the buttons during various Power Modes and transitions.
Back Door — this green LED indicates if the straight pass-through
door (located at the back of the scanner) is open or closed.
• LED Off: when the straight pass-through door is closed, the rotary
path to exit tray is in use.
• LED On: when the straight pass-through door is open, scanned
documents will exit through the straight pass-through door.
Power State/Transition Power Mode LED
Off Off
Sleep>Powered up Blinking, fast
Ready>Active Steady green
Ready>Sleep Blinking, fast
Sleep Blinking, slow
Power State/Transition Power Mode LED
Off Control panel and scanner are not on.
Sleep>Ready Buttons are not active during this transition.
Ready>Active All buttons perform their normal functions. Press and
hold the Stop button for 5 seconds to start the
transition process to put the scanner into sleep
mode.
Ready>Sleep The scanner is almost ready to go into sleep mode. A
momentary press of any button resets the sleep
count-down timer.
Sleep A momentary press of any button starts the Sleep >
Awake transition to awaken the scanner.