Kodak 9090DC - Manual (Page 12)

A-61662 October 2011 1-7
Rear view
1 Imprinter door — provides access to the optional imprinter for
installation and maintenance.
2 Straight pass-through door — allows you to use the optional
straight pass-through adapter. When the door is open and the exit
tray is attached, documents are fed through this exit. This is useful
for scanning thick or stiff documents. Only open this door when you
are using the straight pass-through feature, if the door is opened
while scanning in rotary mode, a document jam will occur.
NOTE: When the straight pass-through door is open, the Back Door
status light on the control panel will be lit.
3 SCSI connector — connects an optional SCSI cable (cable and
SCSI card are not provided).
4 USB connector — connects the USB cable to the scanner and
host PC.
5 Fan — for cooling the scanner. The fan is part of the scanner’s
power supply. Make sure to properly vent the scanner for optimal
performance.
6 Power connector — connects the power supply to the scanner.
7 Power switch — turns the scanner on (I) and off (O).
8 Foot — four rubber feet allow for clearance below the scanner.
9 Intake vent (on side) — used for drawing air in for cooling. Be sure
to position the scanner in such a way that the intake vent is not
blocked.
NOTE: Be sure to maintain an additional 4-5 inches (10-13 cm) of
additional clearance at the front, back and sides of the scanner
for proper ventilation.
1
2
3
4
5 6 7
8
9