Kodak 9090DC - Manual (Page 78)

B-4 A-61662 October 2011
10. Connect the imprinter cable to the connector on the imprinter unit
noting the orientation of the key on the plug and the slot on the con-
nector.
11. Close the imprinter door.
12. Replace the exit tray.
13. Turn on the scanner and the PC.
14. Launch the Ngenuity Operator Utility and confirm the imprinter is
recognized.
NOTE: Do not leave the ink cartridge in the imprinter when not in use.
Removing the front
imprinter 1. Turn off the scanner.
2. Remove the exit tray.
3. Open the front page imprinter door.
4. Unplug the imprinter cable.
5. Unscrew the thumb screw located on the right side of the imprinter.
6. Pull the spring-loaded locating pin on the left side of the imprinter
unit away from the wall of the scanner.
7. Lift the imprinter up and out of the scanner.
8. Close the front page imprinter door, reinstall the exit tray and turn
on the scanner.