Kenwood AX-7 - Manual (Page 23)

23 EN
Preparations
Basic section
Application section
Knowledge section
2
Adjust the day of week.
1 Adjust the day of week
2
Press the SET key.
As the clock is not only used to show the time of the day but also used in timer operations, be sure to set
the clock adjustment in advance.
Clock adjustment
Example: Adjustment to Monday 8:07
1
Select "TIME ADJUST".
÷ The time display starts to blink.
÷ After the day is input, the hour display starts to blink.
1
Press the MODE key, turn the INPUT SEL./
MULTI CONTROL knob to select "TIME
ADJUST". Then press the SET key.
3
Adjust the hour.
Example: Adjustment to Monday 8:07
÷ After the hour is input, the minute display starts to
blink.
1
Adjust the hour
2
Press the SET key.
Turn POWER ON. ¢
4
Adjust the minute.
÷ If you made a mistake, restart from the beginning.
÷ When the time of day has been set by pressing the
SET key, the display shows "COMPLETE".
÷ After a power failure or the AC power cord has been
unplugged, the time set will be cleared. You have to set
the time again when the unit is switched on.
÷ When the 7 (STOP) key is pressed while the power is
in the standby mode, the time of day will be displayed
for 5 seconds.
1
Adjust the minute.
2
Press the SET key.
Example: Adjustment to Monday 8:07
L
R
30 10 5 3 1 0(-dB)
1 2 3 4 5
L
R
30 10 5 3 1 0(-dB)
1 2 3 4 5
L
R
30 10 5 3 1 0 (-dB)
1 2 3 4 5
L
R
30 10 5 3 1 0 (-dB)
1 2 3 4 5
Increase Decrease
*5613/23-38/EN 06.1.6, 0:53 PM 23