Kenwood AX-7 - Manual (Page 49)

49 EN
Preparations
Basic section
Application section
Knowledge section
DVD MD TUNER CONTROL PRE-AMPLIFIER SOUND SELECTOR INPUT SEL. / MULTI CONTROL VOLUME
MODE
SET
D.AUDIO PHONES D.AUDIO
standby
/ timer
0
1. Connecting a digital audio player
Recording to a digital audio player
Use a commercial cord with stereo mini plugs to connect the D.AUDIO OUT
terminal of this unit and the recording input terminal of the digital audio player.
When connecting a digital audio player, first switch off the
power for the digital audio player and for this unit before mak-
ing the connection.
Then switch on both units.
2. Select an input source
TUNER
DVD/CD
TAPE/VIDEO1, VIDEO2, TV or AUX
÷ Select an input source other than D.AUDIO.
When a digital audio player with direct encoding function is connected, the sound played back by this unit
can be recorded by the digital audio player.
1.
2.
0
3. Preparing the recording source
TUNER : Tune in to the station.
DVD/CD : Pause playback at the start of the track or chapter to be
recorded.
TAPE/VIDEO1, VIDEO2, TV, AUX (external input) : Make the prepa-
rations for reception or playback.
÷ Adjust the recording level if the recorded sound is distorted or too low.Q
The following settings are guide values.
DVD/CD, TUNER : REC LEVEL 0
Other external input sources : The value set by external input
level adjustment. i
Select an
input source
Continued to next page
*5613/46-51/EN 06.1.6, 0:54 PM 49