Kenwood AX-7 - Manual (Page 69)

69 EN
Preparations
Basic section
Application section
Knowledge section
Timer operation
7
Put the unit in standby mode.
Press the (POWER) key.
÷ When the unit enters the Standby mode, the
STANDBY/TIMER indicator lights in green.
÷ If there is a power failure or the AC power cord is un-
plugged after the timer reservation has been activated,
the STANDBY/TIMER indicator blinks in green. In this
case, the clock setting should be restarted from the
beginning.
Deactivating and activating the timer program
Once the timer setting procedure has been performed, the timer program can be deactivated or acti-
vated easily.
When the unit is in on, press the TIMER key on
the remote.
Each press of the TIMER key changes the items ;
1 Activate PROG.1 timer.
2 Activate PROG.2 timer.
1, 2 Activate both PROG.1 and PROG.2
timer.
Deactivate the timer. (Timer indicator is off.)
÷ The timer program contents remain even if the timer is
deactivated.
÷ After a power failure or the AC power cord has been
unplugged, the STANDBY/TIMER indicator blinks in
green. In this case, set the present time, and then go
through the timer setting procedure again.
*5613/65-71/EN 06.1.6, 0:54 PM 69