Kenwood AX-7 - Manual (Page 70)

70 EN
Preparations
Basic section
Application section
Knowledge section
Setting DIMMER functions
Select DIMMER mode.
Press the DIMMER key on the remote control
unit to select DIMMER mode.
Procedure on the main unit
1 Press the MODE key, turn the INPUT SEL./
MULTI CONTROL knob to select "DIMMER
SET". Then press the SET key.
2 Turn the INPUT SEL./MULTI CONTROL knob
to switch the brightness.
3 Press the SET key.
Each time the key is pressed, the mode switches.
L
R
30 10 5 3 1 0(-dB)
1 2 3 4 5
÷ The brightness of the display part of the main amplifier
M-AX7 also is switched.
Switching as shown below is done each time
the knob is turned.
“DIMMER OFF”: Normal brightness
“DIMMER ON”:
Brightness of the display is reduced.
÷ Return to the original display is made after approx. 3 sec.
*5613/65-71/EN 06.1.6, 0:54 PM 70