Turning the scanner off, Starting and stopping scanning, Document preparation – Kodak i1800 Series User Manual
Page 19
A-61555 March 2007
3-3
Turning the scanner
off
• Press the power switch on the left-side of the scanner to the off (O)
position.
NOTES:
• You do not need to turn the main breaker switch off unless you are
going to move the scanner.
• There are four leveling feet on the bottom of the scanner. If you need
to move the scanner, these leveling feet must be raised. Contact your
Kodak Service Representative before attempting to relocate the
scanner.
Starting and stopping
scanning
The scanner is controlled by a capture software application. To start
and stop scanning, refer to the documentation provided with your
application software.
Document
preparation
Kodak Scanners have been tested with a range of documents that
represent the broad spectrum of document types found in the most
common business applications. Optimal scanner performance is
achieved when scanning documents within the recommended
document specifications listed below. Scanning documents outside of
these specifications may lead to undesirable results in terms of scanner
reliability, image quality, and/or consumable life.
Materials:
• Virgin, recycled and photographic papers
• Clear protective sleeves meeting the size and thickness
requirements in this section
Paper Types: Bond, Laser, Inkjet, Offset
Paper Weights: The input elevator handles a broad range of paper
weights from
45 to 200 g/m
2
(12 to 110 lb.). The Kodak Feeder Kit for
Ultralightweight Paper can handle paper weights from 25 to 75 g/m
2
(7 to 20 lbs).
Minimum Document Size: 6.4 x 6.4 cm (2.5 x 2.5 in.).
Maximum Document Size: 30.5 x 86 cm (12 x 34 in.). Documents
larger than 43 cm (17 in.) may require operator assistance and
installation of optional document extenders.
Paper inks: All inks on the paper must be dry before scanning is
started. This includes: Standard offset printing, Inkjet printer, Thermal
transfer, Handwriting inks.
Correction Fluids: Liquid Paper®, Tipp-Ex®, Wite-out®, and other
similar correction fluids must be dry before scanning is started.