Kodak i1800 Series - Manual (Page 52)

3-36 A-61555 March 2007
Power Saver mode
The Kodak i1800 Series Scanners are configured from the factory to go
into Power Saver mode after 15 minutes of inactivity. This setting can
be changed by your capture software application. If Power Saver is
enabled, the scanner will begin a one-minute count-down prior to
entering Power Saver mode. When the scanner is in Power Saver
mode, the green LED will be flashing and the touchscreen will be blank.
NOTE: If you do not want to go into Power Saver mode, touch Cancel.
Resuming from Power Saver mode
• If there is paper in the input elevator, take the paper out and put it
back in.
• If no paper is in the input elevator, put paper in the input elevator.
The initializing screen will appear on the touchscreen.
Viewing messages
The message window provides an up-to-date status of scanner activity
and/or any operator messages. Only one message can be displayed at
a time. To review previous messages use the Operator Log.