Lincoln Electric POWER FEED IM892-C - Manual (Page 22)

B-6 OPERATION B-6
POWER FEED™ 25M
LED condition
Steady green
Blinking green.
Blinking green, fast
Blinking green fol-
lowed by blinking
red.
Definition
System okay. The power source and wire feeder are communicating normally.
Occurs during a reset and indicates the power source is identifying each component in the system. This is
normal for up to 15 seconds after power-up, or if the system configuration is changed during operation.
Indicates that one or more pieces of ArcLink equipment are not mapping properly. Check the DIP switch set-
ting on the wire feeders.
Non-recoverable system fault. If the power source or wire feeder status LED is flashing any combination of
red and green, errors are present in the system. Read the error code before the machine is turned off.
Error codes are detailed in the Troubleshooting Section E. Individual code digits are flashed in red with a
long pause between digits. After each error code the LED will flash green and codes will repeat. There may
be more than one error code indicated.
To clear the error, turn the power source OFF, and then back ON to reset. See Troubleshooting Section E.
STATUS LED
(See Table B.1)
The status LED indicates system status. Normal
operation is a steady green light.
Note: During normal power-up, the LED may flash
red and/or green as the equipment performs self tests.
STAT US
TABLE B.1
11. ON-OFF SWITCH
The On-Off Switch turns the wire feeder power on and
off. It does not control the power to the welding power
source.
ELECTRIC SHOCK can kill.
• Turn the input power OFF at the
welding power source before
installation or changing drive
rolls and/or guides.
• Do not touch electrically live
parts.
• When inching with the gun trigger, electrode and
drive mechanism are "hot" to work and ground
and could remain energized several seconds
after the gun trigger is released.
• Welding power source must be connected to
system ground per the National Electrical Code
or any applicable local codes.
• Only qualified personnel should perform mainte-
nance work.
------------------------------------------------------------------------
WARNING