Lincoln Electric POWER FEED IM892-C - Manual (Page 9)

A-2 INSTALLATION
POWER FEED™ 25M
A-2
SAFETY PRECAUTIONS
ELECTRIC SHOCK CAN KILL.
• Turn the input power OFF at the
welding power source before
installation or changing drive rolls
and/or guides.
• Do not touch electrically live parts.
• When inching with the gun trigger,
electrode and drive mechanism are
"hot" to work and ground and
could remain energized several
seconds after the gun trigger is
released.
• Welding power source must be connected to
system ground per the National Electrical Code
or any applicable local codes.
• Only qualified personnel should perform mainte-
nance work.
------------------------------------------------------------------------
LOCATION
For best wire feeding performance, place the POWER
FEED™ 25M on a stable and dry surface. Keep the
wire feeder in a vertical position. Do not operate the
wire feeder on an angled surface of more than 15
degrees.
Do not submerge the POWER FEED™ 25M.
The POWER FEED™ 25M is rated IP23 and is
suitable for outdoor use.
The handle of the POWER FEED™ 25M is intended
for moving the wire feeder about the work place only.
When suspending a wire feeder, insulate the hanging
device from the wire feeder enclosure.
HIGH FREQUENCY PROTECTION
Locate the POWER FEED™ 25M away from radio
controlled machinery. The normal operation of the
POWER FEED™ 25M may adversely affect the oper-
ation of RF controlled equipment, which may result
in bodily injury or damage to the equipment.
------------------------------------------------------------------------
WARNING
CAUTION