Lincoln Electric POWER FEED IM892-C - Manual (Page 42)

B-26 OPERATION B-26
POWER FEED™ 25M
Parameter Definition
Exit Setup Menu
P.0 This setup menu parameter can be used to exit the setup menu. When P.0 is displayed, press
the left Mode Select button to exit the setup menu.
P.1 Wire Feed Speed Units
P.1 selects which units wire feed speed will be displayed in. English = in/minute wire feed speed
units (default). Metric = m/minute wire feed speed units.
P.2 Arc Display Mode
P.2 selects what value will be shown on the upper left display while welding. Amps = The left
display shows Amperage while welding (default). WFS = The left display shows Wire Feed
Speed while welding.
P.3 Display Energy
P.3 selects whether or not energy is displayed on the MSP4 while welding. The total energy
from the previous weld will persist on the MSP4 display until another weld is started, or a user
interface control is changed. P.3 will only show up in the list if the power source is capable of
calculating energy (a power source software update may be necessary). When P.3 = No, ener-
gy will not be displayed (default). When P.3 = Yes, energy is displayed.
P.4 Recall Memory with Trigger
Allows the operator to recall a memory by quickly pulling and releasing the gun trigger. To recall
a memory, quickly pull and release the trigger the number of times that correspond to the mem-
ory number. For example, to recall memory 3, quickly pull and release the trigger 3 times. To
recall memory 1, quickly pull and release the trigger the number of user memories plus 1.
Memories cannot be recalled while the system is welding. A memory panel must be installed in
order to use this feature.
Disabled = The gun trigger cannot be used to recall user memories (default).
Enabled = The gun trigger can be used to recall user memories.
USER DEFINED PARAMETERS