Figure f.28, E figure f.28, Troubleshooting and repair – Lincoln Electric POWER WAVE 355M User Manual
Page 109: Dc bus board removal and replacement (continued)
DC BUS BOARD REMOVAL AND REPLACEMENT
(continued)
TROUBLESHOOTING AND REPAIR
F-63
F-63
POWER WAVE 355M/405M
9. Label and remove two thermostat leads and four
leads from the bus rectifier.
10. Using a 3/8” open end wrench, remove the three
DC Bus Board mounting nuts. See Figure F.29.
11. Replace the DC Bus Board.
12. Secure the new DC Bus Board in its proper loca-
tion using the 3/8” mounting nuts.
13. Reconnect previously removed leads to their prop-
er locations.
14. Replace the four phillips head screws mounting
the two welder output terminals to the front of the
machine.
15. Replace the two phillips head screws from above
and below the input power switch.
ST
STA
ATUS
TUS
THERMAL
THERMAL
_
+
Phillips Head
Screws
Phillips Head
Screws
5/16"
Mounting Screws
FIGURE F.28 CASE FRONT SCREW REMOVAL
FIGURE F.29 CASE FRONT SCREW REMOVAL
L
1
1
0
7
8
-1
J46
J47
3/8" Mounting
Nuts
Thermostat
Bus
Rectifier