Ri gh t s id e, Troubleshooting and repair, Mounting nuts (3/8") – Lincoln Electric POWER WAVE 355M User Manual
Page 96: Control board removal and replacement (continued)
TROUBLESHOOTING AND REPAIR
F-50
F-50
POWER WAVE 355M/405M
CONTROL BOARD REMOVAL AND REPLACEMENT (continued)
12. Using a 3/8” nut driver remove the two mounting
nuts from the top two corners of the control
board. See Figure F.20.
13. Cut any necessary cable ties.
14. Replace the control board.
15. Replace the two 3/8” mounting nuts at the top
two corners of the control board.
16. Replace any previously removed cable ties.
17. Replace plugs #J2, #J4, #J5, #J6, #J7, #J8, #J9,
#J10B, and #J10A previously removed.
18. Replace the two screws and their washers from
above and below the input power switch.
19. Replace the four screws from around the two
welder output terminals on the front of the
machine.
20. Replace the two case front mounting screws at
the bottom of the front of the machine.
21. Replace the case wraparound cover.
FIGURE F.20 CONTROL BOARD MOUNTING SCREW LOCATION
Ri
gh
t S
id
e
Mounting
Nuts (3/8")