Lucent Technologies 9077 16S - Manual (Page 118)

B-4 October 22, 1999 SP Switch Router Adapter Guide - 1.4 Update 2
Log Messages
Message descriptions
CONTEXT: RUNNING
SEVERITY: INFO
DESCRIPTION: This message is logged when the TX-CPU sends an ACK service
message to the switch manager. This message was/is used primarily as a debug tool to
debug the SP switch manager code.
“ARP added: IP= %s, SW-node=%d, state=%d”
SOURCE_FILE: tx/tbsi_arp.c
LOG_FILE: /var/log/gr.console
SCOPE: CARD
CONTEXT: RUNNING
SEVERITY: INFO
DESCRIPTION: This message is logged whenever the TX-CPU adds an ARP entry to the
ARP table.
“Bad Hdr/Svc received, Ret code=%d”
LOG_FILE: /var/log/gr.console
SOURCE_FILE: rx/tbsi_svc.c
SCOPE: CARD
CONTEXT: RUNNING
SEVERITY: WARNING
DESCRIPTION: This message is logged when a bad service message header is received.
This is an indication that there was some sort of error on the link.
“Board Configuration timed-out, retrying”
LOG_FILE: /var/log/gr.console
SOURCE_FILE: rx/main.c
SCOPE: CARD
CONTEXT: RUNNING
SEVERITY: INFO
DESCRIPTION: This message is logged when a timed-out condition has occurred while
the SP Switch Router Adapter card is waiting for it configuration parameters from the
RMS. The card will retry, no actions need to be taken.
“Broadcasting an ARP Request.”
“Broadcasting a Gratuitous ARP Request”
LOG_FILE: /var/log/gr.console
SOURCE_FILE: tx/tbsi_arp.c
SCOPE: CARD
CONTEXT: RUNNING
SEVERITY: INFO
DESCRIPTION: This message is logged whenever the TX-CPU broadcasts an ARP
request or a gratuitous ARP message.