Lucent Technologies 9077 16S - Manual (Page 122)

B-8 October 22, 1999 SP Switch Router Adapter Guide - 1.4 Update 2
Log Messages
Message descriptions
“Initializing RX Subsystem data structure.”
LOG_FILE: /var/log/gr.console
SOURCE_FILE: rx/tbsi_rx.c
SCOPE: CARD
CONTEXT: RUNNING
SEVERITY: INFO
DESCRIPTION: This message is logged when the RX Side is ready to initialize its
subsystem to bring the up the interface.
“IOSTB3:RX SET TOD service message received.”
LOG_FILE: /var/log/gr.console
SOURCE_FILE: rx/tbsi_svc.c
SCOPE: CARD
CONTEXT: RUNNING
SEVERITY: INFO
DESCRIPTION: This message is logged every time a SET TOD service message is
received. Historically, this type of message was used to aid debugging between the switch
manager and the card.
“Loopback routes found for IP adr: 0x%x, sw-node.”
LOG_FILE: /var/log/gr.console
SOURCE_FILE: tx/tbsi_arp.c
SCOPE: CARD
CONTEXT: RUNNING
SEVERITY: INFO
DESCRIPTION: This message is logged when the TX CPU has failed to find a switch
node address for an IP address. Not resolving the switch node address is normal for a
node(s) which once existed on the network but has since been fenced.
“Lost of STI clock, TBIC Status = 0x%x.”
LOG_FILE: /var/log/gr.console
SOURCE_FILE: rx/tbsi_svc.c
SCOPE: CARD
CONTEXT: RUNNING
SEVERITY: ERROR
DESCRIPTION: This message is logged when the TBIC’s STI clock (status bit) becomes
invalid. Status is the TBIC’s status register.
“Lost of STI clock, TBIC Status = 0x%x.”
LOG_FILE: /var/log/gr.console
SOURCE_FILE: tx/tbsi_svc.c
SCOPE: CARD
CONTEXT: RUNNING
SEVERITY: ERROR
DESCRIPTION: Logged when the TBIC’s STI clock (status bit) becomes invalid.