Lucent Technologies 9077 16S - Manual (Page 42)

2-8 October 22, 1999 SP Switch Router Adapter Guide - 1.4 Update 2
Configuring the SP Switch Router Adapter
Installing the PCMCIA spinning disk
# Blank lines and lines beginning with `#' are comments.
#
/dev/rd0a / ufs rw 0 0
/dev/wd2a /var/log ufs rw 0 2 #PCMCIA slot A, use wd3a for B
4 Edit the file /etc/syslog.conf to specify the location where the logs will be kept.
Uncomment the local log configuration lines in the “Log messages to Disk” section
by removing #disk# from each line and specify /var/log as the directory for each log:
These are the first four lines in the section:
#disk#*.err;*.notice;kern.debug;lpr,auth.info;mail.crit
/var/log/messages
#disk# cron.info /var/log/cron
#disk# local0.info /var/log/gritd.packets
#disk# local1.info /var/log/gr.console
The file entries should now look like the following:
*.err;*.notice;kern.debug;lpr,auth.info;mail.crit
/var/log/messages
cron.info /var/log/cron
local0.info /var/log/gritd.packets
local1.info /var/log/gr.console
local2.* /var/log/gr.boot
local3.* /var/log/grinchd.log
local4.* /var/log/gr.conferrs
local5.* /var/log/mib2d.log
If you had previously configured your SP Switch Router to log messages to a directory
other than
/var/log , you changed settings in /etc/grclean.conf and
/etc/grclean.logs.conf files.
Go back into those files now and change the log directory.
5 To install your changes, restart syslog:
Determine the PID (process ID) for the syslog daemon and then use the kill -HUP PID
command to restart it:
# ps -ax | grep syslogd
# kill -HUP PID
6 Modify /etc/grclean.conf and /etc/grclean.logs.conf to reflect the new log
directory.
The /etc/grclean.conf file specifies which log and dump files the grclean program
compresses, archives, and deletes.
The /etc/grclean.conf file entries should look like the following:
#################################################################
# port card dump files.
#################################################################