Lucent Technologies 9077 16S - Manual (Page 51)

Configuring the SP Switch Router Adapter
Step-by-step media card configuration
SP Switch Router Adapter Guide - 1.4 Update 2 October 22, 1999 2-17
4 Run dev1config to create /etc/grdev1.conf .
The SP Switch Router requires a specific configuration file, /etc/grdev1.conf , for the
SP Switch Router Adapter card to operate. The dev1config command creates this skeleton
file using configuration information passed to the router in either of two ways:
a. We recommend using the procedures documented in the “Managing Extension Nodes”
chapter of the PSSP Administration Guide. to install the parameters. (This is the same
configuration information as described in the recommended method of step 2.) These
parameters will only be available to dev1config after the SP Switch Router Adapter card is
activated on the SP switch.
or:
b. As an alternative, you can log on to the SP Switch Router and use a UNIX editor to
enter the parameters in the
/etc/grdev1.conf file.
5 Reset the SP Switch Router Adapter card to install configuration files.
Details about each step are provided in the next several sections.