Lucent Technologies 9077 16S - Manual (Page 119)

Log Messages
Message descriptions
SP Switch Router Adapter Guide - 1.4 Update 2 October 22, 1999 B-5
“Configuration Parameters:”
The associated parameters can be any of the following:
Slot Number..........: %d
Node Number..........: %d
Node Name............: %s
SW Token.............: %s
Arp Enabled..........: %d
SW Node Number.......: %d
IP...................: 0x%x
IP Mask..............: 0x%x
Max Link Size........: %d
Host Offset..........: %d
Config State.........: %d
System Name..........: %s
Node State...........: %d
Switch Link Chip.....: %d
Transmit Delay.......: %d
LOG_FILE: /var/log/gr.console
SOURCE_FILE: rx/tbsi_cnfg.c
SCOPE: CARD
CONTEXT: RUNNING
SEVERITY: INFO
DESCRIPTION: This message is logged when the SP Switch Router Adapter card
receives its configuration parameters.
“Configuring transmit side.”
LOG_FILE: /var/log/gr.console
SOURCE_FILE: rx/tbsi_ipc.c
SCOPE: CARD
CONTEXT: RUNNING
SEVERITY: INFO
DESCRIPTION: This message is logged when the RX-CPU is ready to send
configuration parameters to the TX-CPU.
“CPU ready msg received from TX-CPU”
LOG_FILE: /var/log/gr.console
SOURCE_FILE: rx/tbsi_ipc.c
SCOPE: CARD
CONTEXT: RUNNING
SEVERITY: INFO
DESCRIPTION: This message is logged when the TX-CPU is loaded and configured.