Lucent Technologies 9077 16S - Manual (Page 128)

B-14 October 22, 1999 SP Switch Router Adapter Guide - 1.4 Update 2
Log Messages
Message descriptions
“Switch Route table loaded, %d entries.”
LOG_FILE: /var/log/gr.console
SOURCE_FILE: tx/tbsi_svc.c
SCOPE: CARD
CONTEXT: RUNNING
SEVERITY: INFO
DESCRIPTION: This message is logged when the transient switch route table has been
moved to the permanent switch route table resulted from the processing of a Load Routes
service message.
“TB4 segment received in error.”
"TB4-HDR word%d: 0x%x.”
LOG_FILE: /var/log/gr.console
SOURCE_FILE: rx/tbsi_rx.c
SCOPE: CARD
CONTEXT: RUNNING
SEVERITY: WARNING
DESCRIPTION: This message is logged when a TB4 segment was received in error. The
TB4 header and the message data are included in the log.
“TB4 segment received in wrong state.”
LOG_FILE: /var/log/gr.console
SOURCE_FILE: rx/tbsi_rx.c
SCOPE: CARD
CONTEXT: RUNNING
SEVERITY: WARNING
DESCRIPTION: This message is logged when a TB4 segment is received while the SP
Switch Router Adapter card’s state machine is not in RUNNING or QUIESCED state. The
TB4 header and the message data are included in the log. This happens when a node sends
data packets to the SP Switch Router Adapter card without knowing that the card interface
is down.
“TBIC INIT msg sent to TX-CPU.”
LOG_FILE: /var/log/gr.console
SOURCE_FILE: rx/tbsi_ipc.c
SCOPE: CARD
CONTEXT: RUNNING
SEVERITY: INFO
DESCRIPTION: This message is logged when the RX-CPU sends a message to the
TX-CPU to initialize the TBIC. The RX-CPU will then wait for a TBIC INITED message
from the TX-CPU.