Lucent Technologies 9077 16S - Manual (Page 35)

SP Switch Router Adapter Guide - 1.4 Update 2 October 22, 1999 2-1
2 Configuring the SP Switch Router Adapter
This chapter describes configuration and installation tasks required to connect an SP Switch
Router Adapter media card to an IBM SP System.
The RS/6000 SP Switch Router is based on the GRF 400 and GRF1600 routers manufactured
by Lucent Technologies. For that reason, this manual contains references to the
GRF 400/1600 Getting Started, GRF Reference Guide, and GRF Configuration and
Management manuals. The SP model of a GRF router is referred to as the SP Switch Router.
For more information about configuration as related to the SP, see the PSSP Administration
Guide and the PSSP Command and Technical Reference. For additional information on
troubleshooting your configuration, see the PSSP Diagnosis Guide.
Chapter 2 covers these topics:
Introduction to installation and configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-2
Installing an SP Switch Router Adapter card. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-5
Installing the PCMCIA spinning disk . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-6
Attaching SP Switch Router cables . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-10
Configuration required on the SP system. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-12
Step-by-step media card configuration. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-16
Step 1. Check SNMP in the SP Switch Router system . . . . . . . . . . . . . . . . . . . . . . . . 2-18
Step 2. Assign IP addresses . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-21
Step 3. Change profile settings. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-24
Step 4. Run dev1config to create grdev1.conf . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-31
Step 5. Reset card to install files . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-35
Verify SP Switch Router Adapter card from router . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-36
Bringing the SP Switch Router Adapter card on-line with the SP. . . . . . . . . . . . . . . . 2-40