Specify different executables, Specify different dump settings – Lucent Technologies 9077 16S User Manual

Page 59

Advertising
background image

Configuring the SP Switch Router Adapter

Step 3. Change profile settings

SP Switch Router Adapter Guide - 1.4 Update 2

October 22, 1999

2-25

Specify different executables

A media card’s Card profile can be used to specify a custom binary setting that overrides the
standard media binary configured in the system Load profile.

Card-specific executables can be set at the Card profile in the

load

/

hw-table

field. The

hw-table

field is empty until you specify the path name of a new run-time binary. This

specified run-time binary will execute in this SP Switch Router Adapter card only.

super> read card 8

CARD/8 read

super> list card 8

card-num* = 8

media-type = dev1

debug-level = 0

hssi-frame-protocol = Frame-Relay

sonet-frame-protocol = PPP

ether-verbose = 0

ports = <{ 0{off on 10 3} {single off} {"" "" 1 sonet internal-osc+

load = { 0 < > 1 0 0 }

dump = { 0 < > off off}

config = { 0 1 1 4 0 0 }

icmp-throttling = { 10 10 2147483647 10 10 10 }

super> list load

config = 0

hw-table = < >

boot-seq-index = 1

boot-seq-state = 0

boot-seq-diagcode = 0

If you want to try a test binary, specify the new path in the

hw-table

field:

super> set hw-table = /usr/libexec/portcard/test_exec_for_dev1

super> write

CARD/8 written

Specify different dump settings

A media card’s Card profile can be used to specify custom dump settings that override the
system options configured in the system Dump profile.

Card-specific dump file names can be set at the Card profile in the

dump

/

hw-table

field. The

hw-table

field is empty until you specify a new path name where you want dumps for this

card to be kept.

super> read card 8

card/8 read

super> list dump

config = 0

hw-table = < >

config-spontaneous = off

dump-on-boot = off

In a Card profile’s

config

field you can specify when dumps will be taken for a particular

card. You set the field equal to a value that represents a certain event or several such events. You
can specify the value in either hex or decimal. However, after you save (write) your specified

Advertising
This manual is related to the following products: