List the filters per media card - maint 50, List where filters are assigned - maint 54, Configure udp packet discards - maint 89 7 – Lucent Technologies 9077 16S User Manual

Page 95

Advertising
background image

Monitoring and Management Tools

SP Switch Router Adapter card maint commands

SP Switch Router Adapter Guide - 1.4 Update 2

October 22, 1999

3-19

[RX] note, IF/ID may be '-1' to indicate all of the given

[RX] item while detail level is 0|1|2.

Please refer to the “IP Packet Filtering” chapter in the GRF Configuration and Management
manual for a full discussion of the filtering command set. A few examples are shown here.

List the filters per media card - maint 50

The filters are listed per interface:

GR 0> maint 50 gt000

[RX]

[RX] filterID type status access

[RX] 00000022 ctable (loaded) 0002

You need the grfutil command to decipher the filterID value and get the filter name:

# grfutil -f 22

filterID temp BPF SPARC SSPARC C30 CTABLE fname

00000022 No Yes No No No Yes mail_server_allow

You see a message if no filters are found:

GR 0> maint 50

[RX]

[RX] No filters found.

List where filters are assigned - maint 54

This command shows which logical interface numbers (

vlif

) have filter “ID 22” assigned:

GR 00> maint 54 22

[RX] vlif BindID state location filterID action_cnt

[RX] 0000 00000040 FastOp IPin 22 1

[RX] 0000 00000041 FastOp IPout 22 1

[RX] 0001 00000042 FastOp IPin 22 1

[RX] 0001 00000043 FastOp IPout 22 1

Configure UDP packet discards - maint 89 7

The maint 89 7 command provides a way to drop certain packets such as HATS traffic that are
known to be unnecessary. Minimizing unnecessary traffic to the SP Switch Router
management system frees the router’s communication bus for other internal messaging.

A site uses the command to specify that all UDP packets bound for a specified port are
discarded. After the specified UDP port number is entered via maint 89 7 port_number, all
UDP messages with source and destination ports set to port_number are discarded.

This example discards HATS packets and shows how to specify the target UDP port of 10000
on the SP Switch Router Adapter card in slot 13. The “port set” message confirms the setting:

# grrmb

GR 1> port 13

Current port is 13.

GR 13>

GR 13> maint 89 7 10000

Advertising
This manual is related to the following products: