Lanier 5622 - Manual (Page 87)

In accordance with IEC 60417, this machine uses the following symbols for the main power switch:
a a a a means POWER ON.
c
c c c means STAND BY.
Note to users in the United States of America
Notice:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursu-
ant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television re-
ception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio /TV technician for help.
Warning
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
Note to users in Canada
Warning:
This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equip-
ment Regulations.
Remarque concernant les utilisateurs au Canada
Avertissement:
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel
brouilleur du Canada.
Caution (in case of 100BASE-TX environment):
Network interface cable with ferrite core must be used for RF interference suppression.
Copyright © 2001